User's Guide
Table Of Contents
- Product Overview
- Getting Started
- Initial Setup
- Status
- System
- Wireless Networking and Security
- General Configuration
- Access Point
- Client Bridge
- WDS
- Repeater
- Management
- Administration
- Administrator Settings:
- Device Name Settings:
- Management VLAN
- SNMP Settings
- Backup/Restore Settings
- Export Settings (backup your configuration):
- Import Settings (restore from configuration):
- Reset to Factory Defaults
- System Reboot:
- Time and Date Settings
- Automatically set using NTP:
- Daylight Saving Time:
- NTP Settings:
- Date and Time Settings (manually set):
- SSH Management
- Log
- Diagnostics
- Ping Test Parameter:
- Traceroute Parameter:
- Download Technical Support Data:
- LED Control
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
57
Clients
1. To view devices that are currently connected to your network, click on the
Clients tab.
2. Review the client setting information below.
MAC: Displays the MAC address that is connected to the access point
WLAN (SSID): Displays the SSID (wireless network name) of the access
point the device is connected to
Access Point: Displays the wireless MAC address of the access points on
the network that the device is connected to
Signal strength (dBm): Displays the signal strength between the access
point and the client. i.e.: -40 is a stronger signal than -50.
Uptime: Displays the duration the client has been connected to the access
point
Statistics
1. To view statistical data about your access point, click on the Statistics tab.
2. Review the statistics information below.
Clients by SSIDs: Displays the number of clients connected to the access point
in comparison between the different SSIDs (wireless network name). Mouse
over the chart to view a current break-down of the total number of clients
connected to the selected SSID.
Clients by AP: Displays number of clients and traffic per access point.