User's Guide
Table Of Contents
- Product Overview
- Getting Started
- Initial Setup
- Status
- System
- Wireless Networking and Security
- General Configuration
- Access Point
- Client Bridge
- WDS
- Repeater
- Management
- Administration
- Administrator Settings:
- Device Name Settings:
- Management VLAN
- SNMP Settings
- Backup/Restore Settings
- Export Settings (backup your configuration):
- Import Settings (restore from configuration):
- Reset to Factory Defaults
- System Reboot:
- Time and Date Settings
- Automatically set using NTP:
- Daylight Saving Time:
- NTP Settings:
- Date and Time Settings (manually set):
- SSH Management
- Log
- Diagnostics
- Ping Test Parameter:
- Traceroute Parameter:
- Download Technical Support Data:
- LED Control
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
37
4. Click on the wireless network you would like to connect. The information will
automatically fill on the previous screen. You will then need to select and enter
the wireless security.
5. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.