User's Guide
Table Of Contents
- Product Overview
- Getting Started
- Initial Setup
- Status
- System
- Wireless Networking and Security
- General Configuration
- Access Point
- Client Bridge
- WDS
- Repeater
- Management
- Administration
- Administrator Settings:
- Device Name Settings:
- Management VLAN
- SNMP Settings
- Backup/Restore Settings
- Export Settings (backup your configuration):
- Import Settings (restore from configuration):
- Reset to Factory Defaults
- System Reboot:
- Time and Date Settings
- Automatically set using NTP:
- Daylight Saving Time:
- NTP Settings:
- Date and Time Settings (manually set):
- SSH Management
- Log
- Diagnostics
- Ping Test Parameter:
- Traceroute Parameter:
- Download Technical Support Data:
- LED Control
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
36
Wireless Mode: Select the wireless mode to set on the selected wireless
band in client bridge mode
SSID: Manually enter the wireless network name (SSID) you want to
establish connection. Or simply click on Site Survey to scan for available
wireless network (more details below).
Preferred BSSID: Click option and enter the preferred wireless network
you would like to connect to.
Security Mode: Select from the pull-down menu the wireless security that
is used on the wireless network you would like to connect to.
Client Bridge: Scan for wireless networks
Wireless (2.4GHz, 5GHz1, or 5GHz2) > Wireless Network
This section outlines the available features to configure for the wireless 2.4 GHz and
5GHz bands when Client Bridge mode is selected.
1. Log into your management page (see “Access the management page” on page
8).
2. Click on the wireless band you would like to configure and click Wireless
Network.
3. Under SSID section click Site Survey to wirelessly scan for available wireless
networks.