User's Guide
Table Of Contents
- Product Overview
- Getting Started
- Initial Setup
- Status
- System
- Wireless Networking and Security
- General Configuration
- Access Point
- Client Bridge
- WDS
- Repeater
- Management
- Administration
- Administrator Settings:
- Device Name Settings:
- Management VLAN
- SNMP Settings
- Backup/Restore Settings
- Export Settings (backup your configuration):
- Import Settings (restore from configuration):
- Reset to Factory Defaults
- System Reboot:
- Time and Date Settings
- Automatically set using NTP:
- Daylight Saving Time:
- NTP Settings:
- Date and Time Settings (manually set):
- SSH Management
- Log
- Diagnostics
- Ping Test Parameter:
- Traceroute Parameter:
- Download Technical Support Data:
- LED Control
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
13
System Log
Status > System Log
System log keeps track of changes made to the access point.
1. Log into your management page (see “Access the management page” on page
8).
2. Click on the Status tab and click System Log.
Refresh: Clicking Refresh allows the access point to update the log with
any new data that has not been previously logged yet.
Clear: Clears all the data saved previously onto the log.
IPv6 Status
Status > IPv6 Status
This section displays the device’s IPv6 status information
1. Log into your management page (see “Access the management page” on page
8).
2. Click on the Status tab and click IPv6 Status.