User's Guide
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-821DAP
28
Enable SNMP
Management > SNMP Settings
SNMP (Simple Network Management Protocol) is a network management protocol used
to monitor (read) and/or manage (write) multiple network devices on a network. This
preconfigured external SNMP server.
1. Log into your management page (see “Access the management page” on page 13).
2. Click on the Management tab and click SNMP Settings.
3. Review the settings and click Save to save settings.
SNMP: Select enable to enable SNMP feature
Contact: Enter the contact person or contact information for your access point.
Location: Enter an assigned location for your access point.
Community Name (Read only): Enter an assigned name for your access point.
Community (Read/Write): Enter a public and private community name.
Trap Destination Address: Enter the destination IP address of the SNMP trap.
Trap Destination Community Name: Enter the name of the destination community
SNMPv3: Select option to enable or disable SNMPv3
Username: Enter the username
Auth Protocol: Select from the pull down menu the authentication protocol to use
Authentication Key: Enter the authentication key
Priv Protocol: Select the private protocol
Priv Key: Enter the private key
Engine ID: Enter the engine name
4. Click on Save button to apply the settings and then click on the Apply/Discard
Changes button located on the top left section to save the settings.
SSH Management
Management > SSH Management
SSH (Secure SHell) is a form of a CLI (Command Line Interface), a user interface where
commands can be sent to the access point in the form of successive lines of text
(command lines).
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the Management tab and click SSH Management.
3. Select ON and click Save to save settings.
4. Click on Save button to apply the settings and then click on the Apply/Discard
Changes button located on the top left section to save the settings.