User's Guide

TRENDnet User’s Guide

TEW-821DAP

Set date and time

Management > Time and Date Settings

There are two ways to set the access point’s date and time. NTP (Network Time Protocol)

is based on time servers. You can also manually set the router’s date and time.

Note: It is important that the time is configured correctly before setting any schedules.

1. Log into your management page (see “Access the management page” on page 13).

2. Click on the Management tab and click Time and Date Settings.

3. Next to Time Zone, click the drop-down list to select your time zone.

Daylight Saving Time

When using NTP or manual configuration, you may also configure Daylight Saving

feature.

 Enable: Check option to enable daylight savings

 Daylight Saving Offset: Select the offset amount for daylight savings to apply

 Start/End Time: Configure the start and end time of daylight savings.

NTP

1. Review the settings below and click Save to save settings.

 Enable: Check option to enable NTP feature

 NTP Server: Select the NTP server to use

 NTP synchronization: Enter the time of when the access point will continue to

check for NTP updates.

2. Click on Save button to apply the settings and then click on the Apply/Discard

Changes button located on the top left section to save the settings.

Manual

1. Manually set the date and time of the access point by select the from the pull-down

menus.

2. Click on Save button to apply the settings and then click on the Apply/Discard

Changes button located on the top left section to save the settings.