User Guide
© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-821DAP
31
Enable CLI
Management > CLI Settings
To enable the Command Line Interface for batch management or advanced
configuration, select CLI ON and then click Apply.
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the Management tab and click CLI.
3. Select ON and click Apply to save settings.
4. Click on Save/Reload button located on the top left section to apply settings.
LED Controls
Management > LED Control
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the Management tab and click LED Control.
3. Review the settings and click Apply to save settings.
Power LED: Select On to leave Power LED on or Off option to turn off.
LAN LED: Select On to leave LAN LED on or Off option to turn off.
2.4GHz LED: Select On to leave wireless 2.4GHz LED on or Off option to turn off.
5GHz LED: Select On to leave wireless 5GHz LED on or Off option to turn off.
4. Click on Save/Reload button located on the top left section to apply settings.
Maintenance & Monitoring
Reset to factory defaults
Management > Backup/Restore Settings
You may want to reset the access point to factory defaults if you are encountering
difficulties and have attempted all other troubleshooting. Before you reset to defaults, if
possible, you should backup your router configuration first, see “Backup and restore
your router configuration settings” on page 23.
There are two methods that can be used to reset your router to factory defaults.
Reset Button: Located on the front panel of your router, see “Product Hardware
Features” on page 2 . Use this method if you are encountering difficulties with
accessing your router management page.
OR
Router Management Page
1. Log into your management page (see “Access the management page” on
page 16).
2. Click on the Management tab and click Backup/Restore Settings.
3. Click Load Default.
4. Click on Save/Reload button located on the top left section to apply settings.