User Guide

TRENDnet User’s Guide

TEW-821DAP

 Enable: Check box to enable traffic shapping of the selected wireless band

 Incoming Traffic: Enter your network’s inbound traffic limit

 Outgoing Traffic Limit: Enter your network’s outbound traffic limit

 Total percentage: Enter the selected wireless band’s traffic percentage to assign

 SSID: Enter the SSID’s assigned traffic percentage allowed

4. Click on Save/Reload button located on the top left section to apply settings.

Enable SNMP

Management > SNMP Settings

SNMP (Simple Network Management Protocol) is a network management protocol used

to monitor (read) and/or manage (write) multiple network devices on a network. This

preconfigured external SNMP server.

1. Log into your management page (see “Access the management page” on page 16).

2. Click on the Management tab and click Management VLAN.

3. Review the settings and click Apply to save settings.

 SNMP: Select enable to enable SNMP feature

 Contact: Enter the contact person or contact information for your access point.

 Location: Enter an assigned location for your access point.

 Community Name (Read only): Enter an assigned name for your access point.

 Community (Read/Write): Enter a public and private community name.

 Trap Destination Address: Enter the destination IP address of the SNMP trap.

 Trap Destination Community Name: Enter the name of the destination community

 SNMPv3: Select option to enable or disable SNMPv3

 Username: Enter the username

 Auth Protocol: Select from the pull down menu the authentication protocol to use

 Authentication Key: Enter the authentication key

 Priv Protocol: Select the private protocol

 Priv Key: Enter the private key

 Engine ID: Enter the engine name

4. Click on Save/Reload button located on the top left section to apply settings.