Quick Installation Guide

2. Initial Access Point Setup

2. Connect the TEW-821DAP to your router or switch. You may also connect the device directly to a

network port on your computer. If you are connecting to a router or switch, make sure your

computer is connected to the same network.

3. If you are connecting your TEW-821DAP to a PoE router or switch, the device will power on

automatically. If you are connecting to a computer, or a non-PoE router or switch, you will need to

use the included power adapter.

4. To use the power adapter, plug the power adapter into the TEW-821DAP, then plug the adapter

into an electrical outlet. Wait 60 seconds, then confirm that the status LEDs on the front of the

unit are illuminated. Your TEW-821DAP access point is now active. The device is pre-configured

to automatically connect to your network.

5. For your security, each TEW-821DAP comes pre-encrypted with a unique WiFi Name (SSID) and

WiFi Password. You can find your device's SSID and WiFi password on the white labels located

on the device. Use this information to connect to the TEW-821DAP access point. If the

TEW-821DAP is reset, the SSID and WiFi key will also be reset to the default login credentials

located on the white label.

1. Bring the TEW-821DAP to a location of its final installation point.

Preset

Wireless Settings

Wi-Fi Name/SSID

(AC/N)

TRENDnetXXX_5GHz_XXXX

(N/B/G)

TRENDnetXXX_2.4GHz_XXXX

Wi-Fi Password

Management Login

http://tew-821dap

username: admin

password: admin

XXXXXXXXXXXXX

6. No further setup is required, proceed to Section 4 Mounting the Device. To change device

settings proceed to Section 3 Software Controller Management.