User's Guide
Table Of Contents
- Product Overview
- Configuration
- Wireless Networking and Security
- Advanced configuration
- Access Point
- Basic
- Wireless Profile
- Wireless MAC filter
- Band Steering
- Airtime Fairness
- Roaming Support (802.11k)
- RSSI Scanner
- IPv6 Settings
- Static IPv6
- Auto Configuration (SLAAC/DHCPv6)
- Change your IP address
- Captive Portal
- Configure Spanning Tree
- Set date and time
- Daylight Saving Time
- NTP
- Manual
- Manage VLAN
- Traffic Shaping
- Enable SNMP
- Enable CLI
- LED Controls
- Client Bridge
- WDS
- Repeater
- Maintenance & Monitoring
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-821DAP
3
Reset
button
Gigabit PoE port: Plug an Ethernet cable (also called network cables) from
your access point to your router and wired network devices. The Gigabit port
complies with standard 802.3af/at PoE/PoE+ so you can connect to connect the AP
to a PoE switch or injector that complies with 802.3af/at.
Power port (optional): If you are not using PoE to power the AP, you can connect
the power adapter from your access point power port to an available power outlet.
Reset button: Use a sharp tool to press and hold this button for 15 seconds to
reset the access point.
Application Diagram
The access point provides concurrent 867 Mbps and WiFi AC and 300 Mbps WiFi N
combined with AP, Client, WDS and Repeater modes support multiple applications.
Gigabit Port
Power port