User's Guide

© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-821DAP
44
 Operation Mode: Displays the current operating mode for each wireless band
 Wireless Mode: Displays the wireless mode set on each wireless band
 Channel Width: Displays the applied channel width
 Frequency (Channel): Displays the current operating wireless channel
 Tx/Rx Packets: Displays the Transmit (Tx) and Receive (Rx) packet rate
 SSID List: Displays the multiple SSID settings.
Check connected wireless clients
Status > 2.4GHz/5GHz Wireless Client
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the Status tab and click 2.4G or 5G Wireless Client List.
 SSID: Displays the SSID that the client is connected to
 MAC Address: Displays the MAC address of the client that is connected to the
access point
 Mode: Displays the 802.11 wireless mode and the channel width that the client
device is connected.
 Rate: Displays the signal rate the client device is connected.
 Signal: Displays the signal strength in percentage. The higher the number, the
higher the signal strength.
 Kick and Ban: Clicking this option will allow you to kick the client from the
network and ban them as well
System Log
Status > System Log
System log keeps track of changes made to the access point.
1. Log into your management page (see “Access the management page” on page 13.
2. Click on the Status tab and click System Log.
 Refresh: Clicking Refresh allows the access point to update the log with any
new data that has not been previously logged yet.
 Clear: Clears all the data saved previously onto the log.
IPv6 Status
Status > IPv6 Status
1. Log into your management page (see “Access the management page” on page 13.
2. Click on the Status tab and click IPv6 Status.