User's Guide

© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-821DAP
40
Maintenance & Monitoring
Administration
Management > Administration
You may want to change your login credentials for logging into your access point.
Resetting the access point to factory default settings will also reset the login credentials
back to factor default which can be found on the label or on the back of the unit.
1. Log into your management page (see “Access the management page” on page 13.
2. Click on the Management tab and click Administration.
3. Review the settings and click Apply to save settings.
 Account: Change the login user name in this field
 Password: Change the login password in this field
 Idle Timeout: Change the length of time that the access point can idle before
timing out. The duration can be between 120 – 3600 seconds. (By default it is
set to 120 seconds)
Device Name
Management > Administration
1. Log into your management page (see “Access the management page” on page 13.
2. Click on the Management tab and click Administration.
3. In the Device Name field, change the name of the device (eg: room, office etc)
4. Click on Apply button to apply the settings and then click on the Save/Reload button
located on the top left section to save the settings.
Reset to factory defaults
Management > Backup/Restore Settings
You may want to reset the access point to factory defaults if you are encountering
difficulties and have attempted all other troubleshooting. Before you reset to defaults, if
possible, you should backup your access point’s configuration first.
There are two methods that can be used to reset your access point to factory defaults.