User's Guide
Table Of Contents
- Product Overview
- Configuration
- Wireless Networking and Security
- Advanced configuration
- Access Point
- Basic
- Wireless Profile
- Wireless MAC filter
- Band Steering
- Airtime Fairness
- Roaming Support (802.11k)
- RSSI Scanner
- IPv6 Settings
- Static IPv6
- Auto Configuration (SLAAC/DHCPv6)
- Change your IP address
- Captive Portal
- Configure Spanning Tree
- Set date and time
- Daylight Saving Time
- NTP
- Manual
- Manage VLAN
- Traffic Shaping
- Enable SNMP
- Enable CLI
- LED Controls
- Client Bridge
- WDS
- Repeater
- Maintenance & Monitoring
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-821DAP
37
Repeater
Basic
Wireless (2.4GHz or 5GHz) > Wireless Network
This section outlines the available features to configure for both wireless 2.4GHz and
5GHz when Repeater mode is selected.
1. Log into your management page (see “Access the management page” on page 13.
2. Click on System, and select Operation Mode.
3. Enable Repeater, under the wireless band (2.4GHz or 5GHz) you would like to connect
this access point to. Please make sure that the selected band is available on your
network.
4. Click on the wireless band (Wireless 2.4GHz / Wireless 5GHz) you would like to
configure and click Wireless Network.
5. Configure the below settings and click Apply to save settings.
Wireless Mode: Select the wireless mode to set on the selected wireless band in
client bridge mode
SSID: Manually enter the wireless network name (SSID) you want to establish
connection. Or simply click on Site Survey to scan for available wireless network.
Preferred BSSID: Click option and enter the preferred wireless network you would
like to connect to.