User's Guide
Table Of Contents
- Product Overview
- Configuration
- Wireless Networking and Security
- Advanced configuration
- Access Point
- Basic
- Wireless Profile
- Wireless MAC filter
- Band Steering
- Airtime Fairness
- Roaming Support (802.11k)
- RSSI Scanner
- IPv6 Settings
- Static IPv6
- Auto Configuration (SLAAC/DHCPv6)
- Change your IP address
- Captive Portal
- Configure Spanning Tree
- Set date and time
- Daylight Saving Time
- NTP
- Manual
- Manage VLAN
- Traffic Shaping
- Enable SNMP
- Enable CLI
- LED Controls
- Client Bridge
- WDS
- Repeater
- Maintenance & Monitoring
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-821DAP
33
Preferred BSSID: Click option and enter the preferred wireless network you would
like to connect to.
Security Mode: Select from the pull-down menu the wireless security that is used
on the wireless network you would like to connect to.
Scan for wireless networks
Wireless (2.4GHz or 5GHz) > Wireless Network
This section outlines the available features to configure for both wireless 2.4Ghz and
5GHz when Client Bridge mode is selected.
1. Log into your management page (see “Access the management page” on page 13.
2. Click on the wireless band you would like to configure and click Wireless Network.
3. Under SSID section click Scan to wireless scan for available wireless networks.
4. Click on the wireless network you would like to connect. The information will
automatically fill on the previous screen. You will then need to select and enter the
wireless security.
5. Click on Apply button to apply the settings and then click on the Save/Reload button
located on the top left section to save the settings.