User's Guide

© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-821DAP
31
3. Review the settings and click Apply to save settings.
 SNMP: Select enable to enable SNMP feature
 Contact: Enter the contact person or contact information for your access point.
 Location: Enter an assigned location for your access point.
 Community Name (Read only): Enter an assigned name for your access point.
 Community (Read/Write): Enter a public and private community name.
 Trap Destination Address: Enter the destination IP address of the SNMP trap.
 Trap Destination Community Name: Enter the name of the destination community
 SNMPv3: Select option to enable or disable SNMPv3
 Username: Enter the username
 Auth Protocol: Select from the pull down menu the authentication protocol to use
 Authentication Key: Enter the authentication key
 Priv Protocol: Select the private protocol
 Priv Key: Enter the private key
 Engine ID: Enter the engine name
4. Click on Apply button to apply the settings and then click on the Save/Reload
button located on the top left section to save the settings.
Enable CLI
Management > CLI Settings
CLI (Command Line Interface) is a user interface where commands can be sent to the
access point in the form of successive lines of text (command lines).
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the Management tab and click CLI Settings.
3. Select ON and click Apply to save settings.
4. Click on Apply button to apply the settings and then click on the Save/Reload button
located on the top left section to save the settings.
LED Controls
Management > LED Control
1. Log into your management page (see “Access the management page” on page 13.
2. Click on the Management tab and click LED Control.
3. Review the settings and click Apply to save settings.
 Power LED: Select On to leave Power LED on or Off option to turn off.
 LAN LED: Select On to leave LAN LED on or Off option to turn off.
 2.4GHz LED: Select On to leave wireless 2.4GHz LED on or Off option to turn off.
 5GHz LED: Select On to leave wireless 5GHz LED on or Off option to turn off.
4. Click on Apply button to apply the settings and then click on the Save/Reload
button located on the top left section to save the settings.