User`s guide

TRENDnet User’s Guide

TEW-820AP

Selecting WPA Enterprise:

The following section outlines options when selecting WPA (EAP or RADIUS). This

security type is also known as EAP (Extensible Authentication Protocol) or Remote

Authentication Dial-In User Service or RADIUS.

Note: This security type requires an external RADIUS server, Pre-Shared Key only requires

you to create a passphrase.

• Security Mode: Select WPA-Enterprise

• WPA Mode: Select WPA2 Only, WPA Only or Auto (WPA or WPA2). It is

recommended to select WPA2 Only, but if you are not certain you can select Auto.

• Cipher Type: Select AES when using WPA2 only, TKIP when using WPA Only. You

can select TKIP and AES when using Auto (WPA or WPA2)

• RADIUS Server IP Address: Enter the IP address of the RADIUS server. (e.g.

192.168.10.250)

• RADIUS Port: Enter the port your RADIUS server is configured to use for RADIUS

authentication.

Note: It is recommended to use port 1812 which is typical default RADIUS port.

• RADIUS server Shared Secret: Enter the shared secret used to authorize your

access point with your RADIUS server.

Connect wireless devices to your access point

A variety of wireless network devices can connect to your wireless network such as:

Gaming Consoles

• Internet enabled TVs

• Network media players

• Smart Phones

• Wireless Laptop computers

• Wireless IP cameras

Each device may have its own software utility for searching and connecting to available

wireless networks, therefore, you must refer to the User’s Manual/Guide of your

wireless client device to determine how to search and connect to this access point’s

wireless network.

See the “

Appendix” on page 44 for general information on connecting to a wireless

network.