Operation Manual

TRENDnet User’s Guide

TEW-812DRU

1. Log into your router management page (see “Access your router management page”

on page 16).

2. Click on the Advanced tab.

3. Click on the Setup section and click on LAN Setting.

4. In LAN Interface Setting section, Enter the router IP address settings. Click Apply to

save settings.

Note: The DHCP address range will change automatically to your new router IP

address settings so you do not have to change the DHCP address range manually to

match your new router IP address settings.

• IP Address: Enter the new router IP address. (e.g. 192.168.200.1)

• Subnet Mask: Enter the new router subnet mask. (e.g. 255.255.255.0)

Note: You will need to access your router management page using your new

router IP address. (e.g. Instead of using the default

http://192.168.10.1 your new

router IP address will use the following format using your new IP address

http://(new.ipaddress.here)

to access your router management page. You can

also use the default login URL

http://tew-812dru

Set up the DHCP server on your router

N Advanced > Setup > LAN Setting

Your router can be used as a DHCP (Dynamic Host Configuration Protocol) server to

automatically assign an IP address to each computer or device on your network. The

DHCP server is enabled by default on your router. If you already have a DHCP server on

your network, or if you do not want to use your router as a DHCP server, you can disable

this setting. It is recommended to leave this setting enabled.

1. Log into your router management page (see “

Access your router management page”

on page 16).

2. Click on the Advanced tab.

3. Click on the Setup section and click on LAN Setting.

3. Review the DHCP Server settings. Click Apply to save settings.

• DHCP Server: Enable or Disable the DHCP server.