Operation Manual

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-752DRU
40
Wireless Client List
Status > Wireless
You can view the list of active wireless devices currently connected to your router.
1. Log into your router management page (see “Access your router management page
”
on page 25).
2. Click on Status, and click on Wireless.
.
• MAC Address: Displays the current MAC address of your wireless client.
• IP Address: Displays the current IP address of your wireless client.
• Mode: Displays the current mode your wireless client is connected (11a/b/g/n)
• Rate: Displays the current rate your wireless client has established.
• Signal: Displays the signal strength of your wireless client.
.
Check the router system information
Status > Device Information
You may want to check the system information of your router such as WAN (Internet)
connectivity, wireless and wired network settings, router MAC address, and firmware
version.
1. Log into your router management page (see “Access your router management page
”
on page 25).
2. Click on Status and click on Device Information.
System Information
• Time: The current time set on your router.
• System Up Time – The duration your router has been running continuously
without a restart/power cycle (hard or soft reboot) or reset.
• Firmware Version – The current firmware version your router is running.
WAN Information
• Connection Type: Displays the current WAN connection type applied.
• Cable Status: Displays the physical link status of the WAN port
• Network Status: Displays the current WAN connection status.
o Renew (DHCP WAN Type): Click this option to renew your WAN IP
address.
o Release (DHCP WAN Type): Click this option to release the WAN IP
address of your router.
o Connect (PPPoE WAN Type): Click this option to connect to your DSL
ISP
o Disconnect (PPPoE WAN Type): Click this option to disconnect from
your DSL ISP.
• Connection Uptime: Displays the amount of time the WAN connection has been
up and running without any disconnects.