Quick Installation Guide TEW-672GR H/W: V1.
Table of Contents Table of Contents English ...................................................................................................... 1. Before You Start ................................................................................. 2. Hardware Installation ......................................................................... 3. Configure the Wireless Router ........................................................... 1 1 2 3 Troubleshooting .............................................
1. Before You Start Package Contents ? TEW-672GR ? Multi-Language Quick Installation Guide User's Guide CD-ROM ? 1 x RJ-45 Ethernet Cable ? Power Adapter (12V, 1A) ? Installation Requirements A computer with a wired or wireless network adapter properly installed ? Web Browser: Internet Explorer (5.
2. Hardware Installation Note: Gather all information related to your Internet Connection before you start. If necessary, contact your Internet Service Provider (ISP). 1. Verify that you have an Internet connection when connecting your computer directly to the Cable or DSL modem. 2. Connect one end of a RJ-45 cable to one of the TEW-672GR's LAN ports. Connect the other end of the cable to the computer's Ethernet port. 3. Connect one end of a RJ-45 cable to the TEW-672GR’s WAN port.
3. Configure the Wireless Router Note: It is recommended that you configure the Wireless Router from a wired computer. 1. Open your web browser, type http://192.168.10.1 in the Address bar, and press Enter. 2. Enter the User Name and Password, and then click OK. User Name: Admin By default, there is no password. 3. Click Network and then click WAN Setting. Then select the proper Internet connection type. 4. Configure the settings based on information provided by your ISP. Then click Apply.
5. Click Wireless and then click Basic. Enter the desired Wireless Name (SSID) and then click Apply. The default Wireless Name (SSID) is TEW672GR. Note: The example below is for WPA2-PSK security. If you select WPA-PSK or WPA2-PSK, make sure your wireless adapters support WPA or WPA2. If your wireless adapters do not support WPA or WPA2, then select WEP. 6. Select the desired Security Mode, enter the Pass Phrase (Encryption Key) and then click Apply. Your configuration is now complete.
Troubleshooting Q1: I typed http://192.168.10.1 in my Internet Browser's Address Bar, but an error message says “The page cannot be displayed.” How can I get into the TEW672GR's web configuration page? A1: First, check your hardware settings again by following the instructions in Section 2. Second, make sure the LAN and WLAN lights are lit. Third, make sure your TCP/IP settings are set to Obtain an IP address automatically (see the steps below). 1.
Q4: All the settings are correct, but I can not make a wireless connection to the Router. What should I do? A4: First, make sure that the WLAN switch on the back of the router is set to on. Second, double check that the WLAN light on the Router is lit. Third, power cycle the TEW-672GR. Unplug the power to the TEW-672GR. Wait 15 seconds, then plug the power back in to the TEW-672GR.
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with you Local Authority or Retailer for recycling advice.
Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com/register 20675 Manhattan Place Torrance, CA 90501 USA Copyright ©2008. All Rights Reserved. TRENDnet.
