Quick Installation Guide TEG-S80g 2.
Table of Contents English 1. Before You Start 2. Hardware Installation 3. LEDs 1 1 3 4 Technical Specifications Troubleshooting 5 6 Version 09.27.
1. Before You Start Package Contents TEG-S80g ? ? Multi-Language Quick Installation Guide ? Power Adapter (5V DC, 1A) System Requirements ? A computer with a network adapter installed ? Cat-5e or Cat-6 Network Cable The surface must support at least 1.5 Kg for the Switch ? The power outlet should be within 1.
Application 1 Delivers less power to unused ports less power on on on on 2 Delivers less power when devices are off off less power 3 Delivers less power with shorter cable lengths GREENnet Switch 20m 60m 100m Full Power Regular Switch 20m *Max power savings compared with standard TRENDnet switches.
2. Hardware Installation 1. Connect the Power Adapter to the TEG-S80g and then to a power outlet. 2. Connect a CAT-5e or CAT-6 RJ-45 network cable from the computer to an available Ethernet port of the TEG-S80g.
3. LEDs Power Link/ACT Green(Solid): Link to another device. Green(Blinking): Activity is occurring from the link Not Illuminated: Nothing is detected on the port. Green: Power is on Not Illuminated: Power is off 100Mbps/1000Mbps Green: Connection for the port is 2000Mbps (Full) Amber: Connection for the port is 100/200Mbps (Full/Half) Non Illunimated: Connection for the port is 10/20Mbps (Half/Full) or nothing is detected on the port.
Hardware Standards IEEE 802.3 10Base-T IEEE 802.3u 100Base-TX IEEE 802.3ab 1000Base-T IEEE 802.3x Flow Control IEEE 802.3az (draft 2.0) Network Media Ethernet: Cat. 3,4,5, up to 100m Fast Ethernet: Cat. 5, up to 100m Gigabit Ethernet: Cat. 5, 5e,6, up to 100m Data Rate Ethernet: 10Mbps/20Mbps (full-duplex) Fast Ethernet: 100Mbps/200Mbps (half/full-duplex) Gigabit Ethernet: 2000Mbps (full-duplex) Protocol/Topology CSMA/CD, Star Power Consumption Switch Fabric Interface 3.5 Watts (max.
Troubleshooting 1. After connecting the Switch to a power outlet, the LEDs do not turn on. Check the connection of the external power adapter to the TEG-S80g and the power outlet. Also check that the power outlet is receiving power. 2. When I connect a computer to one of the ports on the Switch, the Power and the Link/ACT LED is lit, but I am not getting Gigabit speeds. 1. Check the LEDs. If the 100/1000Mbps LED is amber, the computer's connection speed is 100.
Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase.
WARRANTIES EXCLUSIVE: IF THE TRENDNET PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY SHALL BE, AT TRENDNET'S OPTION, REPAIR OR REPLACE. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Copyright ©2010. All Rights Reserved. TRENDnet.
