User's Guide
Table Of Contents
- Table of Contents
- Product Overview
- Router Setup
- Wireless Networking and Security
- Basic
- ADvanced
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Manually configure your Internet connection
- Clone a MAC address
- Add static routes to your router
- IPv6 Internet Connection Settings
- Prioritize traffic using QoS (Quality of Service)
- Advanced wireless settings
- Set your router date and time
- Create schedules
- Access Control
- Open a device on your network to the Internet
- Enable/disable Application Layer Gateways (ALG)
- Enable/disable UPnP on your router
- Using External USB Storage
- Print Share Utility Installation
- Router Maintenance & Monitoring
- Change your router login password
- Change your device name
- Change your device URL
- Identify your network on the Internet
- Allow remote access to your router management page
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Upgrade your router firmware
- Reboot your router
- Allow/deny ping requests to your router from the Internet
- Check the router system information
- Router Management Page Structure
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-812DRU
42
• User Name: Enter the user name to be used to access your files.
• Password: Enter the password for the user name.
• Permission: Select the permission you will grant to the user
• Enabled: Click to activate user account.
Properly Eject USB device
Advanced > USB > Eject Device
It is recommended to properly eject your USB device to prevent any file corruption.
1. Log into your router management page (see “
Access your router management page”
on page 16).
2. Click on the Advanced tab.
3. Click on the USB section and click on Eject Device.
4. Review the settings.
• Safely remove device: Click this button to eject your USB shared device
• Refresh: Click to refresh the connected USB device list.