User's Guide
Table Of Contents
- Table of Contents
- Product Overview
- Router Setup
- Wireless Networking and Security
- Basic
- ADvanced
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Manually configure your Internet connection
- Clone a MAC address
- Add static routes to your router
- IPv6 Internet Connection Settings
- Prioritize traffic using QoS (Quality of Service)
- Advanced wireless settings
- Set your router date and time
- Create schedules
- Access Control
- Open a device on your network to the Internet
- Enable/disable Application Layer Gateways (ALG)
- Enable/disable UPnP on your router
- Using External USB Storage
- Print Share Utility Installation
- Router Maintenance & Monitoring
- Change your router login password
- Change your device name
- Change your device URL
- Identify your network on the Internet
- Allow remote access to your router management page
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Upgrade your router firmware
- Reboot your router
- Allow/deny ping requests to your router from the Internet
- Check the router system information
- Router Management Page Structure
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-812DRU
32
To configure WDS bridging between TEW-812DRU routers:
1. Log into your router management page (see “
Access your router management page”
on page 16).
2. Click on the Advanced tab.
3. Select wireless band you would like to configure, Wireless 2.4GHz or Wireless 5GHz
and click on WDS.
4. Next to Wireless Distribution System (WDS), in an empty field, enter the MAC
address of the other WDS supported wireless device you are bridging. (e.g.
00:11:22:AA:BB:CC). To save settings, click Apply.
For additional routers, make sure to disable the DHCP server first on all additional
routers and configure the LAN IP address to be different on each router. You will
connect devices to the LAN ports 1-4 only on all additional routers and the WAN port is
not used. Then, repeat the steps for additional routers you are bridging.
Additional wireless settings
Advanced > Wireless (2.4GHz or 5GHz) > Advanced
These settings are advanced options that can be configured to change advanced
wireless broadcast specifications. It is recommended that these settings remain set to
their default values unless you are knowledgeable about the effects of changing these
values. Changing these settings incorrectly can degrade performance.
To configure multiple SSID on your router:
1. Log into your router management page (see “
Access your router management page”
on page 16).
2. Click on the Advanced tab.
3. Select wireless band you would like to configure, Wireless 2.4GHz or Wireless 5GHz
and click on Multiple SSID.
4. Review the Multiple SSID settings, click Apply when finished.