User's Guide
Table Of Contents
- Table of Contents
- Product Overview
- Router Setup
- Wireless Networking and Security
- Basic
- ADvanced
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Manually configure your Internet connection
- Clone a MAC address
- Add static routes to your router
- IPv6 Internet Connection Settings
- Prioritize traffic using QoS (Quality of Service)
- Advanced wireless settings
- Set your router date and time
- Create schedules
- Access Control
- Open a device on your network to the Internet
- Enable/disable Application Layer Gateways (ALG)
- Enable/disable UPnP on your router
- Using External USB Storage
- Print Share Utility Installation
- Router Maintenance & Monitoring
- Change your router login password
- Change your device name
- Change your device URL
- Identify your network on the Internet
- Allow remote access to your router management page
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Upgrade your router firmware
- Reboot your router
- Allow/deny ping requests to your router from the Internet
- Check the router system information
- Router Management Page Structure
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-812DRU
29
4. Review the QoS settings.
• Enable QoS: Enable or Disable the Quality of service through the router.
• Prioritize ACK: Enable or disable ACK prioritization.
• Prioritize ICMP: Enable or disable ICMP prioritization.
5. Select the traffic class you would like to configure for your QoS rule.
6. Review the Inbound/Outbound Class Setting section.
• BW Max Inbound: Enter the maximum download speed of your ISP (Internet
Service Provider).
• Highest/High/Medium/Low/Lowest: Enter the download speeds you would like to
apply on each state of download speeds. This setting is similar to setting the priority
speeds of each class
7. Review the QoS Rule settings. Click Add Rule to add and save the rule to the QoS Rule
List
• IP/MAC Address Filter: Select from the pull down menu the IP address or MAC you
would like to apply and enter the IP address of MAC address.
• Protocol Filter: Select the protocol you would like to apply on the QoS Rule.
• Port Filter: Select the port from the pull down menu you would like to assign on the
QoS rule and enter the port.