User's Guide

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-812DRU
24
1. Log into your router management page (see “Access your router management page”
on page 16).
2. Click on the Advanced tab.
3. Click on the Setup section and click on LAN Setting.
4. In LAN Interface Setting section, Enter the router IP address settings. Click Apply to
save settings.
Note: The DHCP address range will change automatically to your new router IP
address settings so you do not have to change the DHCP address range manually to
match your new router IP address settings.
• IP Address: Enter the new router IP address. (e.g. 192.168.200.1)
• Subnet Mask: Enter the new router subnet mask. (e.g. 255.255.255.0)
Note: You will need to access your router management page using your new
router IP address. (e.g. Instead of using the default
http://192.168.10.1 your new
router IP address will use the following format using your new IP address
http://(new.ipaddress.here)
to access your router management page. You can
also use the default login URL
http://tew-812dru
Set up the DHCP server on your router
N Advanced > Setup > LAN Setting
Your router can be used as a DHCP (Dynamic Host Configuration Protocol) server to
automatically assign an IP address to each computer or device on your network. The
DHCP server is enabled by default on your router. If you already have a DHCP server on
your network, or if you do not want to use your router as a DHCP server, you can disable
this setting. It is recommended to leave this setting enabled.
1. Log into your router management page (see “
Access your router management page”
on page 16).
2. Click on the Advanced tab.
3. Click on the Setup section and click on LAN Setting.
3. Review the DHCP Server settings. Click Apply to save settings.
• DHCP Server: Enable or Disable the DHCP server.