Quick Installation Guide TEG-160WS TEG-240WS H/W: C1
Table of Contents Table of Contents English ...................................................................................................... 1. Before You Start ................................................................................ 2. Hardware Installation ........................................................................ 3. Web Management Utility .................................................................... 1 1 2 3 Troubleshooting .............................................
1. Before You Start Package Contents ? TEG-160WS/TEG-240WS ? Quick Installation Guide ? Utility & User Guide CD-ROM ? 2 Mounting Brackets with Screws ? Power Cord System Requirements ? Web Browser: Internet Explorer (5.0 or above), Netscape (6.0 or above) ? Computer with Network adapter installed ? Optional Mini-GBIC modules (e.g.
2. Hardware Installation Note: 1. After hardware installation is complete, use the Web Browser to configure the TEG-160WS/TEG-240WS. To access the Web Browser configuration, open your web browser, and enter the default IP Address http://192.168.0.1 and default password "admin". Make sure your computer and the TEG-160WS/TEG-240WS are configured to the same network segment. 2. The Mini-GBIC slots are shared with Port 15 and 16 (TEG-160WS) and port 23 and 24 (TEG-240WS) Gigabit Ethernet ports.
3. Web Management Utility Note: If you would like to easily discover all the Web Management Switches on the network, assign IP Address, change the password, and upgrade to new firmware, then install the Web Management Utility. Follow the steps below. For Windows User 1. Insert the Utility & User’s Guide CD-ROM into your computer's CD-ROM Drive and then click Install Utility. 2. Follow the Installation Wizard instructions. Click OK. 3.
4. Click Discovery, and then doubleclick the Switch that appears in the Discovery List. 5. Click the Switch in the Monitor List and then click Configuration setting. 6. Configure the IP Address, Subnet mask, Gateway, and Password. Click Set.
. Click OK. 8. Click Access Web. 9. Type in your Password and then click Login. By default, the Password is admin. For more information regarding the Web-based Smart Utility configuration and advanced settings, please refer to the User's Guide included on the Utility & Driver CD-ROM or TRENDnet's website at www.trendnet.com Register Your Product To ensure the highest level of customer service and support, please take a moment to register your product Online at: www.TRENDnet.
Troubleshooting Q1: After connecting the TEG-160WS/TEG-240WS to a power outlet, the LEDs do not turn on. A1: Check the connection of the power cord to the TEG-160WS/TEG-240WS and the power outlet. Also check that the power outlet is receiving power. Q2: After installing the Web-Management Utility, I clicked Discovery and the Utility is unable to discover the TEG-160WS/TEG-240WS. What should I do? A2: Make sure that the TEG-160WS/TEG-240WS is powered on and that all connections are secure.
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with you Local Authority or Retailer for recycling advice.
Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com/register 20675 Manhattan Place Torrance, CA 90501 USA Copyright ©2008. All Rights Reserved. TRENDnet.
