User manual

4.4 Advanced setting

You can change the settings such as ESSID, channel, operational mode and

so on via the advanced setting. To click the “ Setup ” ” Wireless LAN “

“ Operational Settings “ . Regarding the detail setting and parameters, it will

show on the following table. You can assign the proper parameters to this unit

for good performance.

Figure 5

 Access Point Name: The device name.

 ESSID: Extended Service Set Identifier (Wireless Network Identifier) is

the group name that will be shared by every member of your wireless

network. You will only be able to connect with an Access Point , which

has the same ESS ID.

 Channel: The channel selection. Via the setting to assign the proper

channel for AP.

 Fragmentation Threshold: The parameters of fragmentation.(default

value: 2346)

 RTS Threshold: The parameters of RTS setting.(default value: 2346 )

 Authentications Type:

Open System: Open System is the default authentication algorithm.

Open System authentication is not required to be successful while a STA