a) b) c) d) e) f) a Wall Tile Shower Pan Liquid waterproofing Crack Isolation Tape Concrete b c d f e transitional & modern linear fusion shower pan surface mounted on concrete installation guide www.TrendingAccessibility.
Installation Guide 2 for linear shower pan surface mounted on concrete Required Components (included) b) a) b) c) d) e) f) c) f) e) d) Linear Shower Pan Linear Drain Liquid Waterproofing One Roll Rubberized Crack Isolation Tape 2 - Inside corners of Rubberized Crack Isolation Tape Gasket Membrane 15 - 2 1/2” screws 4 - 3/4” screws a) • • Modern Linear Shower Pan Transitional Linear Shower Pan Required Tools (not included) • • • • • • • • • • • • • • • • • www.trendingaccessibility.
Installation Guide 3 for linear shower pan surface mounted on concrete Step 1 > > > > > > > > > For optimal performance, it is imperative there is a level surface prior to installation of new Linear Shower Pan. Check existing floor to make sure it is level. If it is not, please correct prior to installation. Place the Linear Shower pan in desired location and check to make sure it is level.
Installation Guide 4 for linear shower pan surface mounted on concrete Step 5 > > > > > > > > > Install the drain in accordance with current plumbing and building codes. Step 6 > > > > > > > > > Set the Linear shower pan into place and check to make sure the pan is level. This is important to achieve proper drainage. If you notice any rocking or flexing in the pan, you may need to shim or shave areas.
Installation Guide 5 for linear shower pan surface mounted on concrete Step 9 > > > > > > > > > Again while insuring that your pan has remained level, drill and counter sink holes into the Linear pan. Using cement anchors, attach the pan. Do not aggressively screw and over tighten, as you may force the Linear pan out of level. If required you may drill and countersink anywhere on the surface of the Linear Shower Pan, not only the pre-marked locations.
Installation Guide 6 for linear shower pan surface mounted on concrete Step 13 > > > > > > > > Materials needed for wet room waterproofing. You will now begin waterproofing the wet room. BEST PRACTICE: To achieve the best results, we recommend waterproofing the whole room. Minimum requirements, shown in these instructions, show you that you only have to waterproof the shower zone, which is 6 ½ feet high and about 2 feet outside of the showering area.
Installation Guide 7 for linear shower pan surface mounted on concrete Step 17 > > > > > > > > Make sure the tape overlaps the seams equally. Using the 5” crack isolation tape. Overlap all seams of cement board used on either the floors or walls. Overlap the seam where the Fusion pan and cement board meet. Step 18 > > > > > > > > Using the provided precut piece of gasket membrane, slather area where gasket piece will adhered to the drain area.
Installation Guide 8 for linear shower pan surface mounted on concrete Best Practice > > > > > To achieve the best results, we recommend waterproofing the whole room. Step 21 > > > > > > > > You are now ready to tile. If you are using large format tiles, they must be cut diagonally and laid to follow the pitch in the Fusion Pan (From the corners of the grate frame to the corners of the Fusion Pan). Apply the tile adhesive, and lay the tiles in a regular pattern. www.trendingaccessibility.
