User guide
Installation Guide
www.trendingaccessibility.com info@trendingaccessibility.com
5
for linear shower pan recessed into concrete
Step 9 > > > > > > > >
If the Fusion Pan is above the level of the floor, use
a screed bed to raise the floor.
Check that the Linear Fusion Pan is level on all four
sides.
Fill in any gaps around the perimeter of the pan over
1/8” with latex or acrylic caulk.
Do not use 100% silicone.
Step 12 > > > > > > > >
Begin taping the wetroom floor at the interior corners
of the Linear Fusion Pan using the corner pieces of
the crack isolation tape provided. Using a paint brush
or trowel, slather liquid waterproofing into corner,
press piece into place, then apply liquid waterproof-
ing on top. Make sure to smooth out any creases.
Repeat for additional corners.
Step 11 > > > > > > > >
You will now begin waterproofing the wet room.
BEST PRACTICE: To achieve the best results, we
recommend waterproofing the whole room.
Minimum requirements, shown in these instruc-
tions, show you that you only have to waterproof
the shower zone, which is 6 ½ feet high and about
2 feet outside of the showering area.
Materials needed for wet room waterproofing.
Step 10 > > > > > > > >
Make your final connections to the drain. Make
sure connection is snug but do not over tighten.