Instruction Manual

www.TrendingAccessibility.com | 856-488-9535
Metal Shower Seat Installation Guide
2
Finish the wall with wallboard & fi berglass shower wall.
With two people, locate the desired seat posi on
making sure the top of the seat is between 17”-19’
from the finished fl oor. When measuring, the seat must
be in the down, usable posi on. With a 24’ level, check
from side to side and front to back to ensure the seat is
level. A slight 2-3° rise on the seat from the back wall to
the front of the seat is recommended.
Once posi oned, using a pencil, mark the three screw
holes from both outside wall brackets. Also mark the
three holes from the center wall slide bracket. Be
careful of it’s posi on, the bo om screw needs to be
centered on the middle wall stud with the two top
screws fastening to the 2“x6” (as shown in fi gure 2a.)
Make sure the seat raises and lowers
smoothly. If installed correctly the seat
will remain in the up posi on by itself
and will take li le eff ort to lower it. (as
shown in fi gure 2b.)
Tools Required
• Drill - Electric or Cordless
• 1/4” Drill bit
• 24” Level
• Tape Measure
• Pencil
• Silicone Caulking
• Screw Driver
Parts List
Seat with two wall brackets (a ached)
1 Middle support “slide” bracket
**Moun ng hardware not supplied
due to varia ons in wall backing.
Use appropriate fasteners as
recommended by a qualifi ed
contractor.
Note:
Always check your local
building code