Owner manual

Installation Guide
www.trendingaccessibility.com [e-mail]
12
for adjustable fusion shower pan surface mounted on suboors
Adjustable Fusion Shower Pan - Cutting and Drilling guideline
Additional drilled and
countersunk screws
required if Pan is not
in contact with joists/
concrete floor.
Ensure all the cut edges are supported, then drill, countersink and screw the Pan to the j oists below in around 7.87”
intervals (av oid ing pipes, electric wires, etc.).
Important: Do not cut t he edges that adjoin s u rroun ding f loor. Cutting the Pan m ay reduce flo w rate pe rformance.
Maxim u m cut
Maximum cut
Maxim u m cut
Maxim um cut
Additional timber
Additional timber
Additional timber
Fig.1
Cut usi ng an old o r d isposable handsaw.
Additional fixing points
Fig .2
Cu t t o l e n g t h .
Fig . 3
Cut to a cco mmo da te d i a g o n a l wa ll .
Fig. 4
Cut to acc o mmo d a t e dra in p o i n t .
Fig. 6
If Pan is not in contact w ith joist/concret e floor you m ust drill o ut
and c ounte rsink t he Pan t o ensure it does. Fa i lu re to do th is will allow
unacceptable m ove m ent and m ay c ause floor tiles to crack or becom e loose.
Fig .5
En sure cut e d ge s a r e f i xed .
Do not cut into central
solid oval section
Cutting and Drilling Guidlines