Manual

LLO Installation Instructions TG100153A Issue 3/B 10/04/06

Installation Instructions

LLO

Outside Light Level Sensor

Important: Retain these instructions

Dimensions

Installation

Requirements

UNPACKING

36 mm (1.42”)

60 mm (2.4”)

65 mm (2.16”)

H O

-25 °C

-13 °F

+70 °C

+158 °F

0 %RH

95 %RH

LLO Installation

Instructions

TG100153A

Protection :IP65 (NEMA 4)

(north)

Remove Lid

undo 2 screws

10 mm

(0.4”)

PAGE 1
Installation Instructions LLO Outside Light Level Sensor Important: Retain these instructions UNPACKING LLO Installation Instructions TG100153A Installation 1 Dimensions 36 mm (1.42”) 2 Requirements 60 mm (2.4”) 65 mm (2.16”) a 10 mm (0.
PAGE 2
LLO Installation Instructions Installation (continued) 4 Mount on Wall 4 off Ø 3.5 mm fix using 2 screws minimum 5 Insert Cable Note that IP65 rating is only achieved if the sensor is correctly installed with cable gland fully tightened. 6 Wire to Controller Cable 1.
PAGE 3
Installation Instructions LLO Installation (continued) 7 Set up Range (if required to change from range supplied) - + sw1 sw2 sw3 sw4 On On On On Range (lux) 1000 Off On On On 2000 4000 Off Off On On Off Off Off On 8000 Off Off Off Off 20000 e.g.
PAGE 4
LLO Installation Instructions Installation (continued) 10 Set up IQ Sensor types It is recommended to use SET (Software Tool) for the setting of the sensor type module. For all IQ2 series controllers with firmware verision 2.1 or greater, or IQ3 series controllers, the following SET Unique Sensor References should be used: 2k Light I (2000 lux) 4k Light I (4000 lux) 20k Light I (20000 lux) Alternatively (or for other ranges) enter scaling manually as defined in the table below.