User guide

ManualsBrandsTREND ManualsHardwareHT_S

HT/S Space Humidity and Temperature Sensor Installation Instructions TG200990 Issue 1/A 30/01/08

Installation Instructions

HT/S

Space Humidity and Temperature Sensor

Important: Retain these instructions

2 Installation

1 Unpacking

HT/S Installation

Instructions

TG200990

Dimensions

86 mm (3.39”)

26 mm (1.02”)

86 mm (3.39”)

Requirements

> 50 cm (20”)

1.5 m

(5 ft)

Contents

1 Unpacking .................................................... 1

2 Installation .................................................... 1

3 Maintenance ................................................. 4

4 Disposal ....................................................... 4

Summary of content (4 pages)

PAGE 1
Installation Instructions HT/S Space Humidity and Temperature Sensor Important: Retain these instructions Contents 1 Unpacking .................................................... 1 1 Unpacking 2 3 4 Installation .................................................... 1 Maintenance ................................................. 4 Disposal ....................................................... 4 HT/S Installation Instructions TG200990 2 Installation Dimensions 86 mm (3.39”) 1 86 mm (3.
PAGE 2
HT/S 2 Installation Instructions Installation (continued) 2 Requirements (continued) h j i -5 °C (23 °F) 0 °C (32 °F) H O +40 °C measurement (104 °F) 0 %RH 2 k +55 °C (131 °F) l 3 Remove backplate a b 4 100 %RH non -condensing Mount backplate back box (BESA) 35 mm (1.38”) 35 mm (1.38”) 60 mm (2.36”) wall box wall FR 35 mm (1.38”) ABS 35 mm (1.
PAGE 3
Installation Instructions 2 HT/S Installation (continued) 7 Wire to Controller 2 analogue input channels HT/S IQ1 & IQ2 TH TH I-N I-P IN C IN C (+24V) } temperature } humidity linked for thermistor (T) linked for current (I) earth (ground) screens at IQ end IQ3 0 (0V) N+1 (in) + (+24V) TH TH I-N I-P 0 (0V) N (in) + (+24V) N+1 temperature linked for thermistor (T) N humidity linked for current (I) earth (ground) screens at IQ end HT/S/2% IQ1 & IQ2 IN C (+24V) IN C (+24V) I2N I1N I-P }
PAGE 4
HT/S 2 Installation Instructions Installation (continued) 10 Set up IQ Sensor types It is recommended to use SET (software tool) for the setting of sensor type modules. For all IQ2 series controllers with firmware version 2.