Instructions

15
Depend On Us
14
www.trend-networks.com 240810 Rev 1.
Touch the Power Meter indicator to
show the power meter wavelengths
available and select the appropriate
wavelength for the test.
Reference Cord
Power Meter
Port
Light Source
Port
Plug one end of a reference cord into the light source and the other end into the
power meter as shown below.
Note: This step may be skipped as the power meter will set itself to the
appropriate wavelength, if it is being used with a compatible source.
Touch reference indicator in the
bottom right of the display and
select, Set Reference to zero out
the reference cord.
Touch the Modulation indicator
to open the modulation options
and set the modulation to CW for
continuous wave.
Touch the Source indicator to
show the light source wavelengths
available and select the desired
wavelength for the test. Allow the
light source 2-3 minutes to warm
up and stabilize.
Basic Single Cord PM/LS Operation
EN