Manual
Table Of Contents
- Safety precautions
- Notes on use of these operating instructions
- CHAPTER 1 Your LanXPLORER
- AA Alkaline
- 4 hours under normal operating conditions
- Charging time:
- Operating temperature (min./max.):
- Storage temperature (min./max.):
- Relative humidity:
- 1.3. Equipment included Basic version
- 2.1. LanXPLORER
- 2.2. Power options
- 3.1. Principles
- 3.2. System
- 3.3. RJ45
- 3.4. Fibre-optic cable
- 3.5. Tests
- 3.6. IP
- 3.7. VLAN
- 3.8. WiFi
- 3.9. 802.1x
- 5.1. Ports
- 5.2. Passive wiring
- 5.3. Active wiring
- 5.4. Inline Test
- 5.5. Fibre-optic cable
- 5.6. WiFi
- 6.1. Test summary
- 6.2. Autotest
- 6.3. Wiremap test
- 6.4. Testing a passive route without remote / active Remote
- 6.5. Netmap
- 6.6. Verify
- 6.7. Ping
- 6.8. Voice over IP (VoIP)
- 6.9. Trace Route
- 6.10. Blink
- 6.11. Power over Ethernet (PoE)
- 6.12. Loop
- 6.13. PC Diagnosis
- 6.14. Statistics
- 6.15. WiFi
- 7.1. Safety precautions
- 7.2. Instructions for cleaning SFP modules and patch cables
- CHAPTER 2 Instrument description
- CHAPTER 3 Settings
- CHAPTER 4 Test summary
- CHAPTER 5 Test setup
- CHAPTER 6 Test description and procedure
- CHAPTER 7 Wiring test on fibre-optic conductors and SFP modules
- CHAPTER 8 LanXPLORER Firmware Update
- CHAPTER 9 Spare parts - Socket inserts
Chapter 6
Test Description and Procedure
42
6.2. Autotest
The autotest feature allows the installation to be checked quickly and easily. After pressing
the
AUTOTEST button, the LanXPLORER automatically runs the individual tests set.
Selection of the individual tests in the test series depends on the instrument settings and
the type of wiring to be tested.
6.2.1. Run Autotest
1. Connect the LanXPLORER in the desired manner.
2. Set the Autotest options (the Autotest option settings are described in
Chapter 3.5.2).
3. Select Run to start the Autotest.
6.2.2. Overall pass/fail result
After conclusion of the test series, the LanXPLORER displays an overall pass/fail result as
well as the individual pass/fail results.
Symbol
Overall Autotest results
The Autotest is evaluated as passed all total, when
all individual tests are passed.
The Autotest is evaluated as failed all total, when
at least one individual test was failed.
You can view the results of the individual tests, save the results or make Autotest settings.
Display of individual test results
4. Select the desired individual test.
5. Select More to view additional details on the specific test results.
6. Press Escape to return to the previous screen.
Figure 41: Autotest - Complete
overview