Manual
Table Of Contents
- Safety precautions
- Notes on use of these operating instructions
- CHAPTER 1 Your LanXPLORER
- AA Alkaline
- 4 hours under normal operating conditions
- Charging time:
- Operating temperature (min./max.):
- Storage temperature (min./max.):
- Relative humidity:
- 1.3. Equipment included Basic version
- 2.1. LanXPLORER
- 2.2. Power options
- 3.1. Principles
- 3.2. System
- 3.3. RJ45
- 3.4. Fibre-optic cable
- 3.5. Tests
- 3.6. IP
- 3.7. VLAN
- 3.8. WiFi
- 3.9. 802.1x
- 5.1. Ports
- 5.2. Passive wiring
- 5.3. Active wiring
- 5.4. Inline Test
- 5.5. Fibre-optic cable
- 5.6. WiFi
- 6.1. Test summary
- 6.2. Autotest
- 6.3. Wiremap test
- 6.4. Testing a passive route without remote / active Remote
- 6.5. Netmap
- 6.6. Verify
- 6.7. Ping
- 6.8. Voice over IP (VoIP)
- 6.9. Trace Route
- 6.10. Blink
- 6.11. Power over Ethernet (PoE)
- 6.12. Loop
- 6.13. PC Diagnosis
- 6.14. Statistics
- 6.15. WiFi
- 7.1. Safety precautions
- 7.2. Instructions for cleaning SFP modules and patch cables
- CHAPTER 2 Instrument description
- CHAPTER 3 Settings
- CHAPTER 4 Test summary
- CHAPTER 5 Test setup
- CHAPTER 6 Test description and procedure
- CHAPTER 7 Wiring test on fibre-optic conductors and SFP modules
- CHAPTER 8 LanXPLORER Firmware Update
- CHAPTER 9 Spare parts - Socket inserts
41
CHAPTER 6
Test description and procedure
The availability of individual tests depends on the model version and test setup of the
LanXPLORER. An overview the the tests available is given in Table CHAPTER 4.
6.1. Test summary
This menu shows all tests possible with the current wiring. In addition it shows which tests
have already been performed and the associated pass/fail results.
1. Connect the LanXPLORER in the desired manner.
2. Select the menu point "Tests" on the
standby screen.
Symbol
Overall test results
Test not performed.
Test performed and evaluated as passed.
Test performed and evaluated as failed.
6.1.1. Performing individual tests
1. Select the desired individual test.
2. Perform the test.
The result is stored in the short-term memory and displayed in the test summary.
6.1.2. Resetting test results
1. Select reset all in order to delete all individual tests shown in the test summary.
All test results are deleted from the short-term memory.
1. Select reset selected in order to reset all marked individual tests that are
shown in the test summary.
All test results of the marked individual tests are deleted from the short-term memory.
6.1.3. Saving test results
1. Select Save to store all test results in the current job.
All test results are stored in the current job and can be managed there.
Figure 40: Test summary