Manual

Chapter 3
Settings
26
T-Route (Trace Route)
This menu allows settings to be made for the trace route test.
1. Select the menu point "T-Route".
Option
Description
Target
Select the target address to which the ping
is to be sent. Use the option … to select the
list with the target addresses you have
saved.
Max Hops
Set the maximum number of hops to the
target address.
Timeout Maximum waiting time in seconds.
Type Set ICMP or UDP.
2. Select the desired option.
3. Select the desired test parameters or enter the desired information with the
alphanumeric keys.
4. Save the entry made with Apply. You can exit the menu without saving the
changes with Escape.
Verify
This menu allows settings to be made for comparing netmaps.
1. Select the menu point "Verify".
2. Set the desired option.
3. Save the entry made with Apply. You can exit the menu without saving the
changes with Escape.
Loop
This menu allows settings to be made for the loop test.
1. Select the menu point "Loop".
2. Set the desired option.
3. Save the entry made with Apply. You can exit the menu without saving the
changes with Escape.
Figure 27: Trace Route