Manual
Table Of Contents
- Safety precautions
- Notes on use of these operating instructions
- CHAPTER 1 Your LanXPLORER
- AA Alkaline
- 4 hours under normal operating conditions
- Charging time:
- Operating temperature (min./max.):
- Storage temperature (min./max.):
- Relative humidity:
- 1.3. Equipment included Basic version
- 2.1. LanXPLORER
- 2.2. Power options
- 3.1. Principles
- 3.2. System
- 3.3. RJ45
- 3.4. Fibre-optic cable
- 3.5. Tests
- 3.6. IP
- 3.7. VLAN
- 3.8. WiFi
- 3.9. 802.1x
- 5.1. Ports
- 5.2. Passive wiring
- 5.3. Active wiring
- 5.4. Inline Test
- 5.5. Fibre-optic cable
- 5.6. WiFi
- 6.1. Test summary
- 6.2. Autotest
- 6.3. Wiremap test
- 6.4. Testing a passive route without remote / active Remote
- 6.5. Netmap
- 6.6. Verify
- 6.7. Ping
- 6.8. Voice over IP (VoIP)
- 6.9. Trace Route
- 6.10. Blink
- 6.11. Power over Ethernet (PoE)
- 6.12. Loop
- 6.13. PC Diagnosis
- 6.14. Statistics
- 6.15. WiFi
- 7.1. Safety precautions
- 7.2. Instructions for cleaning SFP modules and patch cables
- CHAPTER 2 Instrument description
- CHAPTER 3 Settings
- CHAPTER 4 Test summary
- CHAPTER 5 Test setup
- CHAPTER 6 Test description and procedure
- CHAPTER 7 Wiring test on fibre-optic conductors and SFP modules
- CHAPTER 8 LanXPLORER Firmware Update
- CHAPTER 9 Spare parts - Socket inserts
Chapter 3
Settings
20
1. Select the menu point "Factory".
2. With Reset returns the instrument to the
factory settings and any settings you have
made are deleted.
3. You can exit the menu without saving the
changes with Cancel or
Escape.
3.3. RJ45
This menu allows configuration of how the RJ45 interface connects to the network.
1. Select Setup.
2. Select the menu point "RJ45".
Option
Description
Auto
Negotiation
Enabled: Automatic recognition of the
network speed.
Disabled: It is necessary to set the
communication rate and mode manually.
Speed
ii
Setting the network speed.
Mode
ii
Full Duplex (all pairs are used for
transmitting and receiving).
Half Duplex (pairs are used for transmitting
or receiving).
Min. Rx Size Smallest recognised packetsize
MDI Configuration of the device interface
MAC
ii
Display of MAC address.
3. Save the entry made with Apply. You can exit the menu without saving the
changes with Escape.
Figure 16: Resetting instrument
to factory settings
Figure 17: RJ45 Settings