Operation Manual

Trend Micro™ ServerProtect™ Getting Started Guide
2-30
e. Press Enter.
Silent install will proceed and the target machine will be registered with the
Information Server.
For silent installation, Normal Servers are installed in the "SMS" domain. There is no
way to change the domain name during the silent installation. You can, however
rename the SMS domain after all the Normal Servers have been installed.
You can also specify a path to which ServerProtect is installed. For example, to
install ServerProtect to the path "
D:\Utility\AntiVirus\Sprotect". Do the
following:
1. Locate the
Setup.ini file in the source folder.
2. Add the following lines:
[CommonSection]
ServerTargetUNCPath=D$\Utility\AntiVirus\Sprotect
Where:
ServerTargetUNCPath: Sets the location where the Normal Server is installed.
To license the installed Normal Server, add the following lines to the
Setup.ini file
in the source folder.
[CommonSection]
ServerTargetSN=XXXX-XXXX-XXXX-XXXX-XXXX
Where:
XXXX-XXXX-XXXX-XXXX-XXXX: Represents the legal serial number.
You may not be able to register a Normal Server under the "SMS" domain due to the
use of a domain controller on the Information Server. To resolve this issue, configure
an IP address before using silent install.
To configure an IP address, do the following:
1. Go to the Setup.ini file in the SMS folder.
2. Replace the host name with its IP address next to AgentName then save the file.