Use and Care Manual

Polyester reinforcing fabric
TremPro Polyester Reinforcing Fabric is 100% stitchbonded, polyester reinforcing fabric.
TremPro Polyester Reinforcing Fabric is designed to be used in conjunction with designated Tremco liquid-
applied products providing additional stability and strength properties to the application.
6” x 50’ roll
White
DO NOT ALLOW ROLLS TO BECOME WET
Recommended storage is indoors in a ventilated, dry area removed from heat, open flame, ignition
sources and direct sunlight. Storage temperatures should range from 60-70°F (15-21°C) and must not
drop below 32°F (0°C) or exceed 110°F (43°C).
On the job site, materials should remain on the pallet until use and be stored in a shaded, ventilated
area. Materials should be covered with a light-colored, reflective tarp for protection against the
elements. Allow for adequate air flow inside the pallets.
Performance could be affected if the product is not stored properly.
Follow preparation/application recommendations for liquid applied products being used in
conjunction with TremPro Polyester Reinforcing Fabric.
Apply TremPro Polyester Reinforcing Fabric as it comes off the roll. Do not flip or invert the
reinforcement during use.
Fully-Reinforced Application: Fully embed TremPro Polyester Reinforcing Fabric into wet liquid
applied product using a brush or roller until reinforcement is fully saturated and is free of voids,
wrinkles, air pockets, standing fibers, etc. In overlap areas ensure wet product is present on
the top of the embedded sheet and overlap side laps a minimum of 3” (76 mm) and end laps
a minimum of 6” (152 mm). Follow the same guidelines to embed the reinforcement in these
areas. Do not allow foot traffic on TremPro Polyester Reinforcing Fabric during application or
until liquid product has cured. Once cured, apply top coat at the specified rate fully covering
the embedded TremPro Polyester Reinforcing Fabric.
Partially-Reinforced System Application: Install a three-course application on all drainage
components, field laps/seams, flashing base and vertical laps/seams, penetrations, etc.
following Tremco detail guidelines. Install the three-course application fully embedding
TremPro Polyester Reinforcing Fabric into wet liquid applied product using a brush or
roller until reinforcement is fully saturated and is free of voids, wrinkles, air pockets,
standing fibers, etc. Then fully encapsulate the TremPro Polyester Reinforcing Fabric with
an additional application liquid applied product.
DESCRIPTION
BASIC USES
PACKAGING
COLOR
STORAGE
APPLICATION
TremPro Polyester Reinforcing Fabric
FEATURES
Highly Conformable
Polyester Technology
Open Weave
BENEFITS
• Conforms to even the most difcult details
• Non rotting, moisture resistant material
• Allows for improved wetting characteristics