Operation Manual

5.8 Entering and changing the PIN anti-theft protection

You can use a PIN to protect your cycle computer from misuse

by unauthorized people. The cycle computer cannot be used

unless the correct PIN is entered. Once the time has been set,

you automatically access the “Change PIN?” window. Here you

can enter your own PIN and, if necessary, subsequently change

it. If you don’t wish to use a PIN, press the MODE button. Other-

wise, after pressing the SET button, you will be asked to enter

the old PIN (default setting is “0000“). To this end, press the

MODE button until such time as the appropriate digit appears

and then use the SET button to move to the next digit. PIN input

is monitored. Should the PIN have been entered incorrectly, the

message “Wrong PIN” appears for approx. 3 seconds and you

will be asked to re-enter the PIN. If the PIN is correct, input a

new PIN of your choice as described above. Once the last digit

has been conﬁ rmed via the SET button, PIN entry must be re-

peated. Should the repeat PIN entry be incorrect, you will return

automatically to the “Change PIN?” window.

Note down your

personal PIN on Page 68 so that it is readily available if required!