User manual
Table Of Contents
- 1) About the SurfTab
- 2) Safety information
- 3) Technical specifications
- 4) Package contents
- 5) Controls and ports
- 6) Starting up the SurfTab for the first time
- 8) Home screen and desktop view
- 9) Charm Bar
- 10) Using and setting up the home screen
- 11) Connecting the SurfTab to the Internet
- 12) Activating Office 365 Personal
- 13) Downloading applications from the Windows Store
- 14) Transferring files between the SurfTab and other devices
- 15) Connecting the SurfTab to a television
- 16) Using the camera
- 17) Automatic Windows Update function
- 18) Performing a system backup
- 19) Reset and recovery
- 20) Switching off the SurfTab
- 21) Notes on copyright and trademarks
- 22) Notes on disposal
- 23) Notes on liability and warranty
EN
25
c) Tap "SETTINGS" in the Charm Bar.
d) Now tap "
CHANGE PC SETTINGS" in the bottom-right area.
e) Tap "
UPDATE AMD RECOVERY" in the bottom-left area and then "CHOOSE HOW UPDATES
GET INSTALLED" (centre of the screen).
f) Under "
IMPORANT UPDATES", select how the SurfTab should proceed with
updates in future.
Further down on the same screen, you can also specify how the SurfTab should
handle other forms of updates ("RECOMMENDED UPDATES" and "MICROSOFT UPDATE").
g) Confirm your selection with "
APPLY".
18) Performing a system backup
To enable a system recovery (including all data) in the event of failure, the
SurfTab allows you to make a "system image" backup. We recommend
performing the backup using an external hard drive. To do so, proceed as follows:
a) Connect an external hard drive to the USB 2.0 port on the SurfTab using a
USB cable.
b) Open the Charm Bar by swiping your finger inwards from the right-hand
edge of the screen.
c) Tap "
SETTINGS" in the Charm Bar.
d) Now tap "
CHANGE PC SETTINGS" in the bottom-right area.
e) Tap "
CONTROL PANEL" in the bottom-left area in the device settings. The Control
Panel in the desktop view opens.
f) Tap "
FILE HISTORY" in the Control Panel.
g) Tap "
SYSTEM IMAGE BACKUP" in the bottom-left area of the following window.
The SurfTab asks whether you would like to save the backup.
h) In this window, select (highlight) "
ON A HARD DISK", and in the drop-down
window directly beneath, select the connected external hard drive as the
target drive for saving the system image.
i) Confirm by tapping "
NEXT" in the bottom-right area of the window. The
SurfTab shows which drives will be backed up. Confirm by tapping "START
BBACKUP".
The system image is created and stored on the hard drive.