MSDS

3 of 7 pages
Last updated 3/03/2009
Aqua Armor for Synthetics Material Safety Data Sheet
MSDS ID NO.: Trek7AASYN Product name: Aqua Armor for Synthetics Page 3 of 7
Special protective equipment for firefighters: None
Flash point: NA – Aqueous base solution
Auto ignition temperature: NA
Flammable limits in air - lower (%): NA
Flammable limits in air - upper (%): NA
NFPA rating:
Health: 1
Flammability: 1
Reactivity: 0
Other: -
HMIS classification:
Health: 1
Flammability: 1
Reactivity: 0
Special: *See Section 8 for guidance in selection of
personal prote
ctive equipment.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions: For large volumes 55 Gallon or greater. Keep public away. Isolate area. Shut off source
if safe to do so. Advise authorities and National Response Center (800- 424-8802) if substance
has entered a watercourse or sewer. Notify local health and pollution control agencies, if
appropriate. Contain liquid with sand or soil. Recover and return free product to proper
containers. Use suitable absorbent materials such as vermiculite, sand, or clay to clean up
residual liquids.
7. HANDLING AND STORAGE
Handling:
Comply with all applicable EPA, OSHA, NFPA and consistent state and local requirements. Store in properly closed containers that
are appropriately labeled and in a cool well-ventilated area.
Do not freeze : If product is frozen the effectiveness of the product may be compromised.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
PERSONAL PROTECTIVE EQUIPMENT
Engineering measures: Local or general exhaust required in an enclosed area or when there is inadequate
ventilation.
Respiratory protection: No respiratory protection should be required.
Skin and body protection: Prolong exposure use Neoprene, nitrile, polyvinyl alcohol (PVA), polyvinyl chloride and
polyurethane gloves to prevent skin contact.
Eye protection: No special eye protection is normally required. Where splashing is possible, wear
safety glasses with side shields.
Hygiene measures: No special protective clothing is normally required.