Quick Start Guide

ENGLISH

Instructions for Use

4. Instructions for Use

There are four types of controller: BionX G2, RIDE+ Pro, RIDE+ EASY and RIDE+ EASY II.

4.1 BionX G2 controller

1• Speed indication 2• Distance, Odometer, Chronometer, Average speed 3• Current assistance

level 4• Current generation level 5• On/Off button 6• Mode-switch

button 7• ‘+’ button 8•

‘-’ button 9• Battery level

• Switching system On / Off

Press any of the two top buttons to switch the system on.

The battery will beep four times, the system will perform a

short self-check (shown on the display as a countdown in the

‘speed’-ﬁeld), and the system will activate (switch to ‘on’).

As soon as the system is ‘on’, the screen will display and each

function will be shown next to its corresponding button.

• Same as in the Quick Start

To switch the system off, press the

button . The battery-

pack will beep ﬁve times. Riding with the system ‘On’ in level 0

is the same as riding with the system ‘Off’. If the bike is left with

the system on, it will automatically switch off after about 10

minutes. Same as in the Quick Start

• Changing the position of the buttons

Normally, the On/Off button

and the mode-switch

button are on the right, and the ‘+’ and ‘-’ buttons on the left.

The functionality of the buttons can be swapped right-to-left.

The code to access this is 2009. More information about

programming via the controller can be found later in this

manual.

• Assistance

When the motor provides power, the bicycle is in assistance

mode. There are four levels of assistance. The level of

assistance is shown by the bar graph on the right, below the

digits for speed. The narrow graph on the display shows the

amount of energy delivered to the motor.