Phone: 800-669-1303 or 801-561-0303 Fax: 801-255-2312 e-mail: treborservice@idexcorp.com SS40-X Surge Suppressor Operation / Maintenance Manual SERIAL NUMBER (located on back of product): PATENTS: U.S.
CONTENTS 1 2 3 INSTALLATION ............................................................................................................ 3 1.1 UNPACKING ...................................................................................................... 3 1.2 LOCATING / MOUNTING SURGE ..................................................................... 3 MAINTENANCE ............................................................................................................ 5 2.
1 INSTALLATION 1.1 UNPACKING After unpacking, the surge suppressor should be checked for any damage that may have occurred during shipment. Damage should be reported to the carrier immediately. The following items should be included within the shipping container: Qty 1 1 1 2’ 1.
Figure 1-2: Maxim 50 PAGE 4 SS40 SURGE OPERATION / MAINTENANCE MANUAL
2 MAINTENANCE 2.1 RECOMMENDED SPARE PARTS KRSS40-00-A Spares Rebuild Kit, which includes: Part No AT002 AT013 2.2 Qty 1 1 Description .020 Thick PTFE Diaphragms Pilot Valve Assembly TOOLS The following tool kit is recommended as standard service equipment. KTSS40-00-A Tool Kit, which includes: Part No 98003108 98003305 T0129 T0146 T0148 2.3 Qty 1 1 1 1 1 Description Torque Wrench, 30-150 Ft. Lb.
2.4 ILL NO 1 2 3 4 5 6 7 8 9 10 11 12 13 14 2.
Insert small flat blade screwdriver in center hole of push plate to prevent shaft from turning. Remove push plate by rotating it CCW. Remove pilot valve boss using 3/4” pin tool to rotate boss CCW. Disassemble pilot boss assembly and replace pilot assembly or other worn parts. Check .020 diameter air bleed port in back wall of suppressor for possible blockage. NOTE: All polypropylene and PTFE parts, when disassembled, should be thoroughly washed and free from acid residue for handling purposes. 2.
3 WARRANTY SS40-X SURGE SUPPRESSOR TREBOR International, Inc. warrants to the purchaser of new equipment manufactured by TREBOR to be free from defects in material and workmanship when used for its intended purpose under normal operating conditions, and maintained according to the Operation/Maintenance Manual.
