Owners manual

7
find not only ferrous metal, but also non-ferrous one (see more details
below).
b. VOLUME—Rotate the control clockwise to power on the unit and
adjust the volume. Rotate it fully counter clockwise to power off the
unit.
c. SENS—Rotate the control clockwise to get higher sensitivity. Rotating
it counter clockwise to decrease it.
d. LOW BAT—Low battery indicator. When LOW BAT indicator lights,
user should replace the battery.
e. View meter—When unit finds any metal target, the meter pointer
swings to the right.
f. Headphone jack—3.5mm headphone jack for connecting headphones
located under the control box.
TESTING AND USING THE DECTECTOR
The metal detector has two operation modes: ALL METAL & DISC. All
metal is used to find all kinds of metal targets. DISC is used to
discriminate the metal type.
The user should first set the operation mode to ALL METAL (smallest 
which is the DISC turned completely counter clockwise), SENS to high
position. Then hold the search coil parallel with the ground about 0-2”
above the surface. Sweep the search coil from side to side in an arc line
of 3” motion.
When the detector detects a buried target, it sounds a tone. User can
make a visual note of exact spot on the ground where the detector
beeps.
Then stop the search coil directly over this point on the ground. Move the
search coil straight forward away from you and straight back towards you
a couple of times. Meantime slowly rotate the DISC control clockwise
away from ALL METAL until the unit does not sound or sounds short tone.
You can identify what kind of metal is detected according to the setting
position of DISC (Discrimination mode).