Datasheet

XRT Wiring Diagram
Remove the 4x16mm button-head cap screws (2) to remove the front
bumper from the bumper mount. Install the front LED light bar on
the front bumper using the included 3x8mm cap screws (2); reinstall
the front bumper. Plug the connector into the high-voltage power
amplifier port A (white).
Route the connectors from
the rear light bar through
the 8mm reamed hole
to the inside of the truck
body. Reinstall the roof
skid. Plug the connectors
(red and blue) into the
long #7882 extension
harness.
Plug the short #7882 extension harness into
the high-voltage power amplifier ports (red
connector to C, blue connector to D).
Plug the other end (large black connector)
into the long #7882 extension harness.
Use the supplied zip ties to secure all wiring to the chassis.
Remove 3x12mm
cap screws (8) to
remove the roof
skid from the truck
body. Attach the
rear LED light bar to
the roof skid using
the included 3x8mm
button-head cap
screws (2).
5 XRT
7 XRT 8 XRT
9 XRT
6 XRT
Front LED Light Bar (white)
Rear LED Light Bar (tail lights) (red)
Rear LED Light Bar (reverse lights) (blue)
Not used (yellow)
3x8mm
CS
3x8mm
CS
3x8mm
BCS
3x12mm
CS
3x12mm
CS
4x16mm
BCS
From Long Extension Harness /
Rear LED Light Bar on Body
High-Voltage High-Voltage
Power Amplier Power Amplier
WiringWiring
Front LED Light Front LED Light
Bar WiringBar Wiring