User Manual
3
Fuel Bottle
Fuel is usually purchased by the gallon or
quart, so a smaller bottle with a dispensing
tube is required to fill the fuel tank. The fuel
tank in the Nitro Stampede has a capacity of
75cc. The fuel bottle should always be capped to
prevent the fuel from evaporating and becoming
contaminated with debris or moisture. The alcohol
and nitro contents of the fuel will evaporate, thus
upsetting the fuel balance and spoiling the fuel. Do
not use old or dirty fuel!
Other Required Equipment
To operate the Nitro Stampede, you will need these additional items.
All of these items should be available from your hobby shop.
1. 8 AA batteries: 4 in the transmitter and 4 for the receiver
2. Small Phillips-head and flat-head screwdrivers (for adjustments)
3. After-run oil (to protect the engine from corrosion)
The TQ 2.4GHz Radio System
Your Nitro Stampede Model 41094 is equipped with the Traxxas TQ
2.4GHz transmitter. The transmitter has two channels: channel one
operates the steering, and channel two operates the throttle. The
receiver inside the model has three output channels. Your model is
equipped with two servos and a receiver.
2.4GHz Spread Spectrum – This model is equipped with the
latest R/C technology. Unlike AM and FM systems that require
frequency crystals and are prone to frequency conicts, the TQ
2.4GHz system automatically selects and locks onto an open
frequency, and offers superior resistance to interference and
“glitching.”
Current – Current is a measure of power ow through the
electronics, usually measured in amps. If you think of a wire as a
garden hose, current is a measure of how much water is owing
through the hose.
Frequency band – The radio frequency used by the transmitter to
send signals to your model. This model operates on the 2.4GHz
direct-sequence spread spectrum.
mAh – Abbreviation for milliamp hour, a measure of the capacity
of the battery pack. The higher the number, the longer the
battery will last between recharges.
Neutral position – The standing position that the servos seek
when the transmitter controls are at the neutral setting.
NiCad – Abbreviation for nickel-cadmium. The original
rechargeable hobby pack, NiCad batteries have very high
current handling, high capacity, and can last up to 1000
charging cycles. Good charging procedures are required to
reduce the possibility of developing a “memory” effect and
shortened run times.
NiMH – Abbreviation for nickel-metal hydride. Rechargeable
NiMH batteries offer high-current handling and much greater
resistance to the “memory” effect. NiMH batteries generally
allow higher capacity than NiCad batteries. They can last up to
500 charge cycles. A peak charger designed for NiMH batteries
is required for optimal performance.
Receiver – The radio unit inside your model that receives signals
from the transmitter and relays them to the servos.
Servo – Small motor units in your model that operate the steering
and throttle mechanisms.
Transmitter – The hand-held radio unit that sends throttle and
steering instructions to your model.
Trim – The ne-tuning adjustment of the neutral position of the
servos, made by adjusting the steering trim knob on the face of
the transmitter.
2-channel radio system – The TQ 2.4GHz radio system, consisting
of the receiver, the transmitter, and the servos. The system uses
two channels: one to operate the throttle and one to operate
the steering.
Included Fuel Bottle
(Part #5001)
Steering
Trim
Throttle
Trigger
Steering Wheel
Power Switch Battery Compartment
Set
Button
Red/Green Status LED
CH3 - Battery
CH2 - Throttle Servo
CH1 - Steering Servo
CH1 - Channel 1*
* Not used
K
A
1
8
6
7
-
R
0
0
KA1867-R00
Antenna
On/Off
Switch
Receiver
4-Cell
Battery Holder
Channel 1
Steering Servo
Channel 2
Throttle Servo