Instruction Manual

GSB/MV Basic Wall Mount Remote AC Adapter

SKU# 250-06096

Page 4 of 8 17602253 10/7/22 © Travis Industries, Inc.

RADIANT STOVE NOTE: If a blower is being uesd, install the blower kit first and discard the power cord and strain

relief bracket from this kit. With the blower kit installed follow the steps below to electricly ground the accessories to

the appliance belly pan.

a. Disconnect the blower ground from the strain relief bracket

b. Install the AC adapter ground to the strain relief bracket where you just removed the blower ground.

c. Reinstall the blower

round on the extra

round tab attached to the remote reciever

round quick reliease.

1. Install the new strain-relief

bracket (stoves and inserts).

For stoves, the strain

relief bracket can be

installed anywhere on

the belly pan of the

appliance that is out of

the way of other

components (see

suggestions to the right).

Insert the stud on the

bracket through an

available hole in the

belly pan. Secure the

bracket with the included

8-32 nut.

With inserts, the bracket installs on the front of the right wall

of the gas control area below the firebox. Use the included

screw to secure the bracket. Use the included screw to

secure the bracket to one of the two existing holes in the

side of the insert (as shown to the right).