Instruction Manual

ManualsBrandsTRAVIS INDUSTRIES HOUSE OF FIRE ManualsAC AdapterTRAVIS INDUSTRIES HOUSE OF FIRE 250-06096 GSB-MV Basic Wall Mount Remote AC Adapter

GSB/MV Basic Wall Mount Remote AC Adapter

SKU# 250-06096

Page 1 of 8 17602253 10/7/22 © Travis Industries, Inc.

Compatibility

 Radiant Large GSB2 & MV

 Radiant Medium GSB2 & MV

 Radiant Small GSB2 & MV

 42 PB Linear GSB2 & MV

 54 PB Linear GSB2 & MV

 72 PB Linear GSB2 & MV

 Northfield MV

 Berkshire MV

 Greenfield MV

 36 PB CF GSB2 & MV

 42 PB CF GSB2 & MV

 Previous GS & MV

units except for the

PB24CF

Packing List

 (1) AC Adapter

 (1) Power Harness Adapter

 (1) Power Cord

 (1) Receiver Adapter Harness

 (1) Strain Relief

 (2) Strain Relief Brackets (Insert and

Stove)

 (1) 8-32 nut

 (1) ¼” drive screw

 (2) zip-ties

Summary of content (8 pages)

PAGE 1
GSB/MV Basic Wall Mount Remote AC Adapter SKU# 250-06096 Compatibility    Radiant Large GSB2 & MV Radiant Medium GSB2 & MV Radiant Small GSB2 & MV    42 PB Linear GSB2 & MV 54 PB Linear GSB2 & MV 72 PB Linear GSB2 & MV    Northfield MV Berkshire MV Greenfield MV    36 PB CF GSB2 & MV 42 PB CF GSB2 & MV Previous GS & MV units except for the PB24CF Packing List  (1) AC Adapter  (1) Power Harness Adapter  (1) Power Cord  (1) Receiver Adapter Harness  (1) Strain Relief  (2)
PAGE 2
GSB/MV Basic Wall Mount Remote AC Adapter SKU# 250-06096 Warnings The transmitter and receiver are radio frequency devices. Placing the transmitter in or near metal may severely reduce the signal range. Turn off power to the heater during installation or maintenance (unplug or turn off power at the breaker). Turn off the main gas supply to the appliance during appliance installation or maintenance.
PAGE 3
GSB/MV Basic Wall Mount Remote AC Adapter SKU# 250-06096 Overview This kit is added to the basic wall-mount remote kit to supply AC power to the remote receiver. The basic installation is the same for MV and GSB stoves and inserts. This kit can also be used with MV and GSB fireplaces but the way the kit connects to AC power is slightly different than with the inserts and stoves (see fireplace installation section for details).
PAGE 4
GSB/MV Basic Wall Mount Remote AC Adapter SKU# 250-06096 RADIANT STOVE NOTE: If a blower is being uesd, install the blower kit first and discard the power cord and strain relief bracket from this kit. With the blower kit installed follow the steps below to electricly ground the accessories to the appliance belly pan. a. Disconnect the blower ground from the strain relief bracket b. Install the AC adapter ground to the strain relief bracket where you just removed the blower ground. c.
PAGE 5
GSB/MV Basic Wall Mount Remote AC Adapter SKU# 250-06096 2. Install the power cord with a strain relief clamp into the bracket. Feed the Molex end of the power cord through the hole in the bracket. Close to the end of the wire insulation place the strain relief on the wire with the sloped end facing the plug end of the cord. Bend the attached plug portion of the strain relief over until it is in line with the slot in the strain relief.
PAGE 6
GSB/MV Basic Wall Mount Remote AC Adapter SKU# 250-06096 4. Connect the green and white wires to the corresponding On/Off switch wires. 5. Connect the blue and white wires from the back of the receiver to the AC adapter. The insulation that covers the quick connects on the AC adapter are different colors. The blue connector should be attached to the blue wire from the receiver and the clear connector should be attached to the white wire. Orientation DOES matter. 6.
PAGE 7
GSB/MV Basic Wall Mount Remote AC Adapter SKU# 250-06096 Wiring Diagram MV Page 7 of 8 17602253 10/7/22 © Travis Industries, Inc.
PAGE 8
GSB/MV Basic Wall Mount Remote AC Adapter SKU# 250-06096 Wiring Diagram GSB2 Page 8 of 8 17602253 10/7/22 © Travis Industries, Inc.