Install Instructions

ManualsBrandsTrapzilla ManualsGrease TrapsTwo-Piece Extension Collar

Thermaco, Inc. • P.O.Box 2548 • Asheboro, NC 27204 • Toll Free: (800) 565-3569

V: (336) 629-4651 • F: (336) 626-5739 • info@thermaco.com • www.trapzilla.com

Trapzilla

ECA-TZ-29 and ECA-TSS-29

Extension Collar Installation Instructions

A THERMACO® Technology

* Bolts (4), Stainless Steel Nuts (4) & Washers (8) provided for bolting the two

sections of the ECA together.

• Washers (4), Brass Nuts (4), and Spacers (4) provided for bolting the combined

ECA to the Trapzilla.

Extension Collar

Parts Provided with the

ECA-TZ-29 and ECA-TSS-29 Extension Collar

WARNING: PROPER INSTALLATION INSTRUCTIONS MUST BE FOLLOWED FOR

THERMACO WARRANTY TO BE VALID. MAXIMUM INSTALLATION DEPTH

PERMITTED FOR TRAPZILLA GREASE INTERCEPTORS AND SOLIDS SEPARATORS

IS 60” MEASURING FROM CENTER OF INLET TO SURFACE. ANY INSTALLATION

DEEPER THAN THIS VOIDS THE WARRANTY FOR THE UNIT. CONTACT THERMACO

REGARDING INSTALLATIONS EXCEEDING THIS DEPTH.

Summary of content (6 pages)

PAGE 1
Trapzilla® ECA-TZ-29 and ECA-TSS-29 Extension Collar Installation Instructions Parts Provided with the ECA-TZ-29 and ECA-TSS-29 Extension Collar Extension Collar * Bolts (4), Stainless Steel Nuts (4) & Washers (8) provided for bolting the two sections of the ECA together. • Washers (4), Brass Nuts (4), and Spacers (4) provided for bolting the combined ECA to the Trapzilla. WARNING: PROPER INSTALLATION INSTRUCTIONS MUST BE FOLLOWED FOR THERMACO WARRANTY TO BE VALID.
PAGE 2
Trapzilla® ECA-TZ-29 and ECA-TSS-29 Extension Collar Installation Instructions Measure the distance from the desired position for the Trapzilla cover and the top of the Trapzilla unit. Add 1-1/2” to this measurement to account for the lip where the lid normally nests. The new dimension is the calculated height for the extension collar(s). A THERMACO® Technology Copyright ©2014 Trapzilla Thermaco, Inc. • P.O.
PAGE 3
Trapzilla® ECA-TZ-29 and ECA-TSS-29 Extension Collar Installation Instructions 22.00 in 22.00 in [55.9 cm] [55.9 cm] The extension collar height as calculated on page 2 determine the steps required to complete the extension collar installation. The ECA-TZ-29 as shipped is naturally adjustable between 17” and 30.5” in height. The following page (page 4) gives instructions for conTop View Top View necting the two collar halves. The remaining pages cover height adjustments. 30.50 in 30.50 in [77.5 cm] [77.
PAGE 4
C D A THERMACO® Technology Screw Track 4 Lower Section Upper Section Copyright ©2014 Trapzilla Thermaco, Inc. • P.O.Box 2548 • Asheboro, NC 27204 • Toll Free: (800) 565-3569 V: (336) 629-4651 • F: (336) 626-5739 • info@thermaco.com • www.trapzilla.com ® 4 3 2 A 646 GREENSBORO STREET PO BOX 2548, ASHEBORO, NC 27203 VOICE 336-629-4651 FAX 336-626-5739 2 PART NO. FINISH (UNLESS NOTED) ENGINEERING CHECKED Angular +/- 1° DRAWN Bolt MATERIAL (UNLESS NOTED) Decimals .XX +/- .03 .XXX +/- .
PAGE 5
Trapzilla® ECA-TZ-29 and ECA-TSS-29 Extension Collar Installation Instructions Setting the Adjusted Collar Height 4 3 1) Extend the collar to match the calculated height as determined on page 2. Figure 1 2) Unscrew the brass nuts and remove the 22” D Diameter Cover from the Trapzilla unit. 3) Using the instructions found on page 4, bolt the two pieces of the Extension Collar together. Use Silicone Sealant (not provided) to seal the space between the two sections of the collar.
PAGE 6
Trapzilla® ECA-TZ-29 and ECA-TSS-29 Extension Collar Installation Instructions Trimming the ECA Extension Collar Upper (Inner) Section: Measure from the Bottom and cut at the bottom of the section. Lower (Outer) Section: Measure from the Top and cut at the top of the section. When trimming the ECA Extension Collar, ALWAYS: 1) Measure from the Top of the Lower (Outer) section & cut the top of the section. 2) Measure from the Bottom of the Upper (Inner) section and cut at the bottom of the section.